DSLRUsers.com

I'm after the part labeled D2220.214 in this diagram-

http://portal.gitzo.com/webdav/site/myj ... 040902.pdf

The stud thats pressed into that part that the locking knob screws onto has snapped off, and I imagine that its going to be close to impossible to get the stud remains out given that they are pressed into a hole about 10mm deep.

Any ideas about who/where/how much/etc?

Cheers,

Luke

Hi Luke,

Adeal (in Victoria) is the place I went thru to obtain a part for my Gitzo G2228

Their website is adeal.com.au.

Their service is dead slow (took 2 months to obtain my part) but had no alternative

Ray