Page 1 of 1

Good place in Sydney to get camera repaired

PostPosted: Mon May 12, 2008 3:46 pm
by isusdfr
I need to get my Pentax K100D SLR repaired. When i open up the menu and try to make any change nine times out of ten before i can get something done the menu closes again. I have tried updating the firmware but the problem is still occuring.
Also I am not sure if this is a fault in the camera or my lens but when using my 70-300mm sigma lens alot of the time even though i have the camera on autofocus it will keep flicking from auto to manual focus. A quick soft tap of the side of the camera will fix it but obviously this is not something i want to keep doing. Also sometimes when turning the camera on with this lens attached it asks for what type of lens it is for the camera shake feature as if I had a fully manual lens attached. It doesnt seem to have this problem when i have my 18-50mm Sigma lens on.

Does anyone know if a good camera repair shop in the sydney/parramatta area?

thanks

Re: Good place in Sydney to get camera repaired

PostPosted: Mon May 12, 2008 5:31 pm
by Glen
Isus, not sure if these guys are good but CRKennedy is the Aus importer for Pentax, their details are:


108-114 Miller Street
Pyrmont NSW 2009
Tel: (02) 9552 8300
Fax: (02) 9552 8399

Re: Good place in Sydney to get camera repaired

PostPosted: Mon May 12, 2008 10:36 pm
by aim54x
sounds like software gremlins, hmm i would talk to CR Kennedy, give them a call. btw how long ago did u buy the camera?