DSLRUsers.com

Has anyone had a problem uploading curves after installing the firmware update?

My computer (both laptop and desktop) used to recognise my camera using Nikon Capture, but post firware update my Capture software wont recognise the camera. The computer still does, so it's not a hardware problem, but the software doesn't seem to like it.

Any advice out there folks???

Thanks in advance.

Sounds like the USB setting is Mass Storage - it needs to be in PTP mode for Capture to see it.

Cheers

I didn't realise this ihad been replied to, sorry to bump an old thread

Does anyone know how to change the usb setting from 'mass storage' to 'PTP' I aint gotta clue, and windows help is about as useful as an ashtray on a motorbike!

Raskill,

This is a camera setting. Can't remember which one.

Cheers
Dean

Yep, I just found it, was hoping to let anyone know before you wasted your time posting. Thanks though Now to upload that custom curve!